Remounting the LED turn signal

Removing the LED turn signal 

• Loosen screws (1)  .
• Pull the LED turn signal (2)  out of the headlight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect the connector (1)  from the LED turn signal (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the LED turn signal 

• Check the seal (1)  on the LED turn signal (2)  for damage and replace it if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the plug connector (1)  to the LED turn signal (2)  and lock it.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LED turn signal (2)  on the headlight.
• Tighten down screws (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  LED turn signal on headlight
  Screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.