Remove auxiliary water pump
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
Preliminary work
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to RELEASING LEFT FRONT-END STRUT .
- Refer to RELEASING THE RIGHT FRONT-END STRUT .
- Refer to REMOVING FRONT CROSS CONNECTION .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING FAN COWL WITH ELECTRIC MOTOR .
- Refer to REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to DRAINING THE COOLANT FROM THE COOLANT PUMPS .
- Refer to DRAINING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to REMOVING OIL FILLER NECK .
- Refer to REMOVING RIGHT CHARGE AIR COOLER .
- Disengage the tank vent valve (2)
from the holder (1)
.
- Disengage the cable bracket (1) from the holder (2) .
- Remove holder (2)
.
- Unlock and disconnect coolant lines (1)
as described in the following.
- Unlock the retaining clips (1) on the flange of the coolant lines (2) upward with a suitable screwdriver (3) .
- Pull off the flanges (2)
of the coolant lines to the rear.
- Loosen screw (1) .
- Turn the auxiliary coolant pump upward.
- Unlock plug connection (2) and disconnect.
- Remove the auxiliary coolant pump.