Mounting seal on the front door

NOTE: TECHNICAL INFORMATION
The repair notes of bonded seals form the basis for these repair notes and must be observed without fail.
For additional information see: 54 10... REPAIR NOTES FOR BONDED SEALS (M5 2018-2022) .

Hang the seal (1) over the door with the open lip facing inwards.
Sealing joint in area (A) position.

Glue seal as follows:

Gradually detach protective film
Align seal (1) corresponding to the specified dimensions (X) or the templates and press on lightly
Check the position of the seal (1) and correct if necessary
Do not overstretch or compress the seal (1) when positioning it
Maximum permissible sag of the seal (1) during the positioning process is 30 mm
Always apply pressure perpendicular to the bonding surface to affix the seal (1)
Affix seal (1) with firm thumb pressure

Courtesy of BMW OF NORTH AMERICA, INC.

Area	Dimension x
A	13 mm
B	6.5 mm
C	4 mm
D	5 mm

Create a sealing joint in area (A), and shorten the seal (1) accordingly as needed.
Position the seal (1) along the template (3):
The edge of the seal (1) is flush with the mark (4) (arrow) of the template (3).
1. Seal
2. Adhesive tape of seal
3. Template
4. Mark for the seal
Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE COVER ON THE INSIDE OF THE WINDOW FRAME .
Refer to INSTALLING FRONT INNER WINDOW CHANNEL STRIP .
Refer to INSTALLING FRONT DOOR TRIM PANEL .
Refer to INSTALLING THE MIRROR TRIANGLE COVER .
Refer to ATTACHING THE COVER TO THE DOOR HANDLE .