Installing the left tension spring for the trunk lid

• Position the gas spring (1) with the ball sockets on the ball hubs and engage with force.

  The gas spring (1) must not be pressed on centrally but must always be pressed onto the ball hubs at the ends of the gas spring (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up works 

• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
• Refer to INSTALLING THE REAR SEAT AND THE REAR SEAT BACKREST (NOT FOR THE SA465 PASS-THROUGH SYSTEM) .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .