Installing the bottom front bumper cover support

• Guide in the support for the bottom front bumper cover (2) and position it correctly.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Support for the bottom bumper panel on the deformation element
  M6x20 screw	Tightening torque	11.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the cover (2).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Cover panel on vertical connection
  Hexagon screw	Tightening torque	4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .