Removing the wheel bearing
WARNING:
Unintentionally applying the parking brake
Injury hazard!
Injury hazard!
- On vehicles with "Remote Engine Start" (SA1CR):
- Starting the engine while working on the braking system is strictly forbidden. When starting the engine via "Remote Engine Start", the parking brake is automatically applied.
- Deactivate the function "Remote Engine Start".
- Open the hood before working on the braking system. This prevents the engine from being started.
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISE THE VEHICLE USING A VEHICLE LIFT .
CAUTION:
Effects on other persons.
Injury hazard! Risk of damage!
Injury hazard! Risk of damage!
- Make sure that no other persons are in or around the vehicle.
NOTE:
TECHNICAL INFORMATION
Before first working on the DSCi brake (integrated brake), the "DSCi" web-based training must be passed successfully.
The "DSCi" web-based training is started in the Learning Management System (TMSi).
Before first working on the DSCi brake (integrated brake), the "DSCi" web-based training must be passed successfully.
The "DSCi" web-based training is started in the Learning Management System (TMSi).
NOTE:
TECHNICAL INFORMATION
After a brake pad exchange and before pressing the brake pedal: It is imperative to apply the electromechanical parking brake.
If this is not observed, a CC message appears and the brake system switches to the emergency program. The brake booster is no longer active.
After a brake pad exchange and before pressing the brake pedal: It is imperative to apply the electromechanical parking brake.
If this is not observed, a CC message appears and the brake system switches to the emergency program. The brake booster is no longer active.
NOTE:
TECHNICAL INFORMATION
During work on the rear brake, it must be ensured that the button for the electromechanical parking brake cannot be pressed.
During work on the rear brake, it must be ensured that the button for the electromechanical parking brake cannot be pressed.
Preliminary work
- Refer to NOTING THE INFORMATION ON THE CARBON CERAMIC BRAKE .
- Refer to REMOVING REAR LEFT OR RIGHT WHEEL .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING REAR BRAKE PADS .
- Refer to REMOVING REAR BRAKE ROTOR .
- Use the special tool 2 472 903 or 5 A47 6E6 to unscrew the spherical-collar screws.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Remove the spherical-collar screws (arrows).
- Remove the wheel bearing (1) .