Lifting rear axle support
- Lift the rear axle support with the special tools 2 219 012 and 0 495 817 (31 5 251) and position it on the body.
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear axle carrier to body | ||
| M12 Replace screw. | Tightening torque | b 108 Nm |
- Lower the special tool 0 495 817 (31 5 251) with the special tool 2 219 012 and place it to the side.
Follow-up work
- Refer to ATTACHING THE CENTRAL MOUNT OF THE PROP SHAFT .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE LEFT AND RIGHT THRUST FIELD .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to SECURING THE CABLE TO THE REAR AXLE SUPPORT .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .