Tightening the screw connection of the top left and right front control arm to the rear axle support

Tightening the screw connection of the upper control arm at the front on the rear axle support 

• Slacken the screw (1)  with the standard tool (2)  by a turn and tighten it. Counter support at the nut with the standard tool (3)  .

  Standard tool: 

  Pivoting extension 1/2 inch 

  Swivel extension 1/2 inch 

  Courtesy of BMW OF NORTH AMERICA, INC.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Swivel extension 1/2 inch (2) 

  Open-end wrench for hexagon head 

  Open-end wrench for hexagon 

  Courtesy of BMW OF NORTH AMERICA, INC.

  Open-end wrench for hexagon

  (3) 

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Upper wishbone at front/rear to rear axle support
  M12 Replace screw and nut. Tighten in NORMAL POSITION .	Tightening via screw Tightening torque	100 Nm

• Fasten the cable (1)  for the electromechanical parking brake on the holder.

Courtesy of BMW OF NORTH AMERICA, INC.