Tightening the screw connection of the left and right camber link on the rear axle support

NOTE: Perform the steps on the left and right side.

Tightening the screw connection of the camber link to the rear axle support

Slacken screw (1) by a turn and tighten it. In doing so, counter support at the nut (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Camber control arm to rear axle support
M14 Replace screw and nut. Tighten in NORMAL POSITION .	Tightening via screw Tightening torque	100 Nm
	Angle of rotation	90°