Tightening the screw connection of the camber link to the shock absorber and the rear axle support
- Slacken the nut (1)
by a turn and tighten it. Provide counter support to screw (2)
in the process.TIGHTENING TORQUE SPECIFICATIONS
Rear shock absorber to the camber control arm M12
Replace screw and nut.
Tighten in the NORMAL POSITION .
Tightening via nut.Tightening torque 100 Nm Angle of rotation 90° - Slacken screw (3) by a turn and tighten it. In doing so, counter support at the nut (4) .
TIGHTENING TORQUE SPECIFICATIONS
| Camber control arm to rear axle support | ||
| M14 Replace screw and nut. Tighten in NORMAL POSITION . |
Tightening via screw Tightening torque |
100 Nm |
| Angle of rotation | 90° | |