Remove the rear left and right brake disc
NOTE:
Perform the steps on the left and right side.
Remove rear brake rotor
NOTE:
RISK OF DAMAGE
Failure to comply with the specification.
Component damage.
Failure to comply with the specification.
Component damage.
- All specifications must be observed and complied with.
- Release the screws (1)
and remove the brake anchor plate in arrow direction.NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment. - Loosen screws (1) .
- Remove the brake disk (2)
.
- Variants with carbon ceramic brake:
Screw in 2 (M8) screws into the internal thread (1) on the brake disc chamber.
Press the carbon-ceramic brake disc of the wheel hub shut.
Screw in screws evenly to avoid distortion of the brake disc chamber during removal.