Fastening the camber control arm on the rear axle support

NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .

Swivel the camber control arm (3) to the top and position it on the rear axle support.
Replace the nut (1) and the screw (2) .
Parts: Nut, bolt
Insert the screw (2) and hand-tighten the nut (1) .
The screw connection is tightened with the torque wrench later in the NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Position the attachment rod (2) on the camber control arm.
Replace nut (1) .
Parts: Nut
Tighten nut (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Attachment rod to wishbone/camber control arm
M6 Replace nut.	Tightening torque	8 Nm