Detaching the bottom wishbone and the camber control arm from the right wheel carrier
NOTE:
Only perform the operation on the right side.
Releasing the bottom wishbone and the camber control arm from the wheel carrier
Precondition
The coil spring is tensioned.
- Mark the position of the eccentric of eccentric screw (3) in relation to the wheel carrier in order to simplify the subsequent adjustment of the rear axle.
- Release nut (1) .
- Remove the eccentric washer (2) .
- Pull out eccentric screw (3)
.
- Loosen screw (1) .
- Release the bottom front wishbone (2)
from the wheel carrier.
- Mark the position of the eccentric of eccentric screw (1) in relation to the camber control arm in order to simplify the subsequent adjustment of the rear axle.
- Release nut (2) and remove the eccentric washer.
- Pull out eccentric screw (1) .
- Release nut (3) .
- Pull out screw (4) .