Attaching the wishbone at the bottom and the camber control arm on the wheel carrier

• Replace the eccentric screw (1)  and the screw (4)  .

  Parts:  Eccentric screw, screw

• Position camber control arm on the wheel carrier.
• Replace the eccentric screw (1)  and insert the screw (4)  .
• Replace the eccentric washer and the nuts (2)  and (3)  .

  Parts:  Eccentric washer, nuts

• Tighten the nut (2)  hand-tight. Turn the eccentric screw (1)  with the eccentric to the mark while doing so.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Hand-tighten the nut (3)  . Counter support at the screw (4)  while doing so.
• Position the wishbone at the bottom front (2)  on the wheel carrier.
• Replace the screw (1)  .

  Parts:  Screw

• Tighten screw (1)  by hand.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: In order to tighten the screw connection with the torque wrench after adjustment work, the direction of insertion of the eccentric screw must be reversed.
• Replace the eccentric screw (1)  , the eccentric washer (2)  and the nut (3)  .

  Parts:  Eccentric screw, eccentric washer, nut

• The eccentric screw (1) must  be inserted from the top.
• Position eccentric washer (2)  .
• Hand-tighten the nut (3)  . Turn the eccentric to the mark.

Courtesy of BMW OF NORTH AMERICA, INC.

The threaded connections are tightened with the torque wrench only later in NORMAL POSITION  or after the wheel alignment.