Attaching the bottom wishbone and the camber control arm to the right wheel carrier

Attaching the wishbone at the bottom and the camber control arm on the wheel carrier 

• Replace the eccentric screw (1)  and the screw (4)  .

  Parts:  Eccentric screw, screw

• Position camber control arm on the wheel carrier.
• Replace the eccentric screw (1)  and insert the screw (4)  .
• Replace the eccentric washer and the nuts (2)  and (3)  .

  Parts:  Eccentric washer, nuts

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the nut (2)  hand-tight. Turn the eccentric screw (1)  with the eccentric to the mark while doing so.
• Hand-tighten the nut (3)  . Counter support at the screw (4)  while doing so.
• Position the wishbone at the bottom front (2)  on the wheel carrier.
• Replace the screw (1)  .

  Parts:  Screw

• Tighten screw (1)  by hand.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: In order to tighten the screw connection with the torque wrench after adjustment work, the direction of insertion of the eccentric screw must be reversed.
• Replace the eccentric screw (1)  , the eccentric washer (2)  and the nut (3)  .

  Parts:  Eccentric screw, eccentric washer, nut

• The eccentric screw (1) must  be inserted from the top.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position eccentric washer (2)  .
• Hand-tighten the nut (3)  . Turn the eccentric to the mark.

The threaded connections are tightened with the torque wrench only later in NORMAL POSITION  or after the wheel alignment.