Removing the coolant feed line part 2 between the auxiliary coolant pump and exhaust turbocharger
WARNING:
Hot fluids
.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE FRONT-END STRUT .
- Refer to REMOVING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
- Refer to REMOVING THE CLEAN AIR PIPE FOR CYLINDERS 1 TO 3 .
- Refer to REMOVING CLEAN AIR PIPE CYLINDERS 4-6 .
- Refer to PARTIALLY REMOVING THE COOLANT EXPANSION TANK OF THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to REMOVING THE FRONT SPOILER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to REMOVING THRUST FIELD .
- Refer to REMOVING THE RIGHT HAND FRONT BOTTOM SIDE COVER .
- Refer to DRAINING THE COOLANT FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Feed out the connector (1) and (2) in arrow direction from the carrier plate (3) and set it aside.
- Unlock plug connection (1) and disconnect.
- Guide out the cable (4)
along the arrows and set aside.
- Unlock plug connection (1)
and disconnect.
- Unlock and release the coolant feed line (1) part 2 at the auxiliary coolant line (2) .
- Catch and dispose of escaping coolant.
- Loosen the screws (1) and (2) .
- Guide out the coolant feed line (3) part 2 and set aside.
- Catch and dispose of escaping coolant.
- Loosen screw (1) .
- Guide out the coolant feed line (2)
part 2 and set aside.
- Guide out and remove the coolant feed line (1) part 2 from the clamp (2) .