26 11 Propeller Shaft, One-Part Or Multi-Part
26 11 TIGHTENING TORQUE OVERVIEW
| Central mount to body | ||
| M8 | Tightening torque | 19 Nm |
| Front flexible disc to prop shaft | ||
| M12 Replace screws. Joining torque and angle rotation must be adhered to. Tightening via screw. |
Joining torque | 55 Nm |
| Angle of rotation | 90° | |
| Propeller shaft to rear axle differential | ||
| recessed nut Replace recessed nut. Carry out the tightening process within 5 min |
Tightening torque | 120 Nm |
| Rear flexible disc to three-hole flange | ||
| M12 Replace screws. Joining torque and angle of rotation must be observed without fail. Tightening via screw. |
Joining torque | 55 Nm |
| Angle of rotation | 90° | |