Installing the bearing bracket for the pedal mechanism
- Install bearing bracket (2).
- Replace the screw (1).
Parts: Screw
- Position and tighten the screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Pedal bracket on body M8 Replace screw. |
tightening torque | 22 Nm |
- Replace nuts (1).
Parts: Nuts
- Install the nuts (1) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake booster to pedal assembly console | ||
| Replace nuts. M8 Retighten 1x on brake booster after 10 min. |
tightening torque | 22 Nm |
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Connect connector (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Connect connector (1).
- Lock brake pedal (1) in place in the arrow direction with the brake booster.
Make sure that the brake pedal is completely locked with the brake booster!
Follow-up work