Removing the hydraulic cylinder of the convertible top cover
Precondition
- Battery charger connected.
NOTE:
Description is for left component only. Procedure on the right side is identical.
CAUTION:
Folding up of convertible top through loss of pressure in hydraulic cylinders.
Injury hazard! Injury hazard by trapping!
Injury hazard! Injury hazard by trapping!
- When carrying out all repair work, secure soft top and soft top compartment lid with a suitable support tool against collapsing. Ensure soft top is supported in the middle.
- Bring the convertible top (1) in the position shown.
- Make sure that the convertible top compartment lid (2) is completely opened.
- Switch off ignition.
The convertible top system will be depressurized after approx. 7 min and can then be moved manually.
NOTE: To make the convertible top system depressurize faster: Long press the audio button. The convertible top system is then depressurized after just a few seconds. - Slightly lift the retaining clip (1) and unclip the hydraulic cylinder (2).
- Release cable tie (1).NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Protect the working area from escaping hydraulic fluid.
- Push out and remove lock plates (1) in the arrow direction.
- Remove hydraulic lines (2).
- Remove the hydraulic cylinder (3).