Installing transmission cross member
- Install the transmission cross member (3).
- Insert the screw (2) and apply hand-tight.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission cross member to body | ||
| M8 | tightening torque | 19 Nm |
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission cross member to rubber mounts | ||
| M12 | tightening torque | 100 Nm |
- Release the luggage strap (1) from the transmission.
- Remove the special tools 0 495 498 (23 4 050) and 2 219 012 from the transmission.
- Install the cover (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission cross member cover | ||
| Nut | Tightening torque | 3 Nm |
- Install the lid (2).
- Engage the locks (1).