Installing the oil-level sensor
- Replace O-ring (1) on oil-level sensor (2).
Parts: O-ring
- Feed in and install the oil-level sensor (2).
- Tighten the nuts (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Oil level sensor to oil sump | ||
|---|---|---|
| hexagon nut M6 Replace nuts. |
Joining torque tightening torque |
2 Nm 8.5 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .
- Refer to REMOVING THE OIL FILLER CAP .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .