Installing rear bumper cover supports

• Install the support for the bumper cover (2).
• Tighten the nuts (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Support on impact plate
  hexagon nut M12	Tightening torque	108 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install rear silencer (2).
• Tighten nut (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear silencer on support
  M8 hexagon nut	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .