33 41 Wheel Bearings
33 41 TIGHTENING TORQUE OVERVIEW
| Output shaft to wheel bearing | ||
| M16 Replace the collar screw. |
Joining torque | 210 Nm |
| Angle of rotation | 90° | |
| Wheel bearing to wheel carrier | ||
| M12 Replace spherical-collar screw. Tighten the spherical-collar screws in crosswise sequence . The tightening sequence must strictly be followed and carried out on all spherical-collar screws at the same time! |
Initial torque | Hand-tighten all spherical-collar screws crosswise. |
| Tightening torque | 120 Nm | |
| Angle of rotation | 90° | |