33 32 Trailing Arms And Struts
33 32 TIGHTENING TORQUE OVERVIEW
| Camber control arm to rear axle support | ||
| M14 Replace screw and nut. Tighten in normal position. Tightening via screw |
Tightening torque | 100 Nm |
| Angle of rotation | 90° | |
| Camber control arm to wheel carrier | ||
| M14 Replace eccentric screw, eccentric washer and nut. |
Tightening torque | 165 Nm |
| Front lower wishbone to rear axle support | ||
| M12 Replace screw. |
Tightening torque | 100 Nm |
| Front lower wishbone to wheel carrier | ||
| M12 Replace screw. Tighten in normal position. |
Tightening torque | 100 Nm |
| Lower rear wishbone to rear axle support | ||
| M12 Replace screw. |
Tightening torque | 100 Nm |
| Lower rear wishbone to wheel carrier | ||
| M12 Replace eccentric screw, eccentric washer and nut. |
Tightening torque | 100 Nm |
| Upper wishbone at front/rear to rear axle support | ||
| M12 Replace screw and nut. Tighten in normal position. Tightening via screw |
Tightening torque | 100 Nm |
| Upper wishbone at front/rear to wheel carrier | ||
| M14 Replace nut. |
Tightening torque | 165 Nm |