Removing all ignition coils
Preliminary work
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING THE ACOUSTIC COVER .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Damage to the ignition coil .
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil .
Damage to the ignition coil .
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil .
- When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
- Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
- Loosen screws (1).
- Feed out plug connection (1) from the holder (2) in arrow direction and set aside.
- Unlock plug connection (1) and disconnect.
- Unlock the lock (1).
- Remove the wiring harness section (2) and put to one side.
- Unlock the locks (arrows).
- Remove the wiring harness section (1) and put to one side.
- Detach holder (1) from the ball pivot (2).
- Lay holder (1) to one side.
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Unlock plug connection (1) and disconnect.
- Loosen screw (2).
- Remove the ignition coil (3).