Installing all ignition coils

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Install ignition coil

TIGHTENING TORQUE SPECIFICATIONS

Ignition coil
screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connector (1) must engage audibly.
Insert and install the holder (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Attach holder (1) to ball pivot (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the wiring harness section (1) and install.
The locks (arrows) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the wiring harness section (2).
The lock (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect connectors (1) and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install plug connection (1) on holder (2) in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Oxygen sensor bracket to cylinder head cover
Self-tapping screw M6	Tightening torque	5.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work