Fastening front brake caliper
- Release the special tool 2 413 317
from the brake caliper (1)
and remove it.
Do not hang the brake caliper (1) from the brake hose.
- Position the brake caliper (1)
in the arrow direction. Do not twist the brake hose in the process.
- Replace nuts (1)
.
Parts: Nuts
- Tighten nuts (1)
.TIGHTENING TORQUE SPECIFICATIONS
Brake caliper on stud bolt of the front swivel bearing M12
Replace nuts.Tightening torque 95 Nm - Fasten the brake hose (1)
on the holder (2)
.NOTE: Only perform the operation on the left side.
- Fasten the cable (3)
for the brake pad wear sensor on to the holder (2)
.