Securing the universal joint on the steering gear
NOTE:
TECHNICAL INFORMATION
The universal joint can be mounted only in one position.
The universal joint and the steering gear or the steering shaft are encoded to each other.
The clamping bolt must be positioned in the groove of the steering gear or the steering shaft.
The universal joint can be mounted only in one position.
The universal joint and the steering gear or the steering shaft are encoded to each other.
The clamping bolt must be positioned in the groove of the steering gear or the steering shaft.
- Clean the screw threads to remove all remnants of screw lock agent.
- Guide in and install universal joint (3) on steering gear (2) .
- Replace the screw (1)
.
Parts: Screw
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Steering shaft to universal joint | ||
| M8 Recut screw thread. Replace clamping bolt. No retorque permitted! |
Tightening torque | 28 Nm |