Installing the engine on the assembly jig
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- Have the set of special tools 0 495 187 (00 2 300) ready.
| Number | Description |
|---|---|
| 1 | Assembly jig |
| 2 | Flange |
| 3 | Crank |
| 4 | cover panel |
| 5 | shelf |
| 6 | Rear shaped part |
| 7 | Collection pan |
| 8 | Front shaped part |
| 9 | Front wheel |
| 10 | Rear wheel with stop |
| 11 | Mat |
- Have the special tool 2 411 718
ready.
- Prepare the assembly stand 0 495 187 (00 2 300)
with the special tool 0 495 196 (00 2 320)
.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
- Screw special tool 2 413 082 together with special tool 0 495 196 (00 2 320) .
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Special tool 2 413 082 to special tool 00 2 320 | ||
| M12x65 | Tightening torque | 100 Nm |
- Remove screws (arrows).
- Feed out and remove the right engine support bracket (1)
.
- Position and secure the special tool 2 411 718 on the engine.
- Tighten the screws (marks).
TIGHTENING TORQUE SPECIFICATIONS
| Special tool 2 411 718 to crankcase | ||
| M10x30 | tightening torque | 38 Nm |
- Slowly lower the engine.
- Ensure that special tool 2 411 718 engages in special tool 2 413 082 .
- Hand-tighten nuts (1)
.
The clamping jaws must be in full contact.
- Release both hooks of the special tool 0 490 561 (11 0 000) at the front of the special tool 2 459 012 and at the rear on the engine from the mounting brackets.
- Remove the special tool 2 220 718 .