Replacement: Remounting the components on the support
NOTE:
Perform the steps on the right and left side.
- Loosen screw (1) .
- Remount fanfare horn (2) .
- Tighten down screw (1)
,TIGHTENING TORQUE SPECIFICATIONS
Fanfare horn to support for bumper cover M6x20 screw Tightening torque 8.8 Nm - Release screws (arrows) and remove holders (1).
- Position holders (arrows) and tighten screws (1). TIGHTENING TORQUE SPECIFICATIONS
Holder to support M6x20 Tightening torque 8 Nm