Installing the hydraulic unit

Position hydraulic unit (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Do not interchange brake lines. If necessary, mark the brake lines before disassembly.
Note various equipment specifications with different line seizure.
Do not bend brake lines.
Close off connecting bores with seal plugs.

Fit brake lines (1) and tighten.

TIGHTENING TORQUE SPECIFICATION

Brake pipe screw connection/Union screws
	tightening torque	17 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) .
Replace the screw (2) .
Parts: Screw.
Position and tighten the screw (2) .

TIGHTENING TORQUE SPECIFICATION

Hydraulic unit with holder on body
Replace screws.	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING COOLANT EXPANSION TANK .
Refer to REMOVING THE BRAKE PEDAL TENSIONER .
Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
Refer to FLUSH AND VENT THE REAR AXLE BRAKE CIRCUIT .
Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
Refer to FLUSH AND BLEED THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .