Installing the electrical vacuum pump
- Install the electrical vacuum pump (1)
in the direction of arrow.
- Replace the screw (1)
.
Parts: Screw
- Insert screws (1) and tighten them.
TIGHTENING TORQUE SPECIFICATION
| Electric vacuum pump to holder | ||
| M6 Replace screws. |
tightening torque | 8 Nm |
- Position the snap fastener (2) and lock it.
- Install the connector housing (2) in the holder.
- Connect the plug connection (1) .
Follow-up work
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .