Install brake caliper in the rear
- Fit and tighten brake hose (2)
on brake caliper.TIGHTENING TORQUE SPECIFICATION
Brake hose to brake caliper, rear tightening torque 24 Nm - Hook the brake hose into the holder (1) .
NOTE:
RISK OF DAMAGE
Incorrect routing of the brake hose .
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail .
Incorrect routing of the brake hose .
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail .
- Do not install the brake hose in a twisted position.
- Insert the brake hose (1) into the body side holder.
- Make sure the retaining spring (2) fits correctly!
- Attach and tighten the union screw (3) .
TIGHTENING TORQUE SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENT THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .