Install the actuator on the left hood hinge
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Feed in the actuator (1) at the guide pin (2) and slide to the back in arrow direction up to the stop.
- Replace the screw (3)
.
Parts: Screw
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATION
| Actuator to engine compartment lid hinge | ||
|---|---|---|
| M6x12 Replace screw. |
Tightening torque | 8 Nm |
- Connect connectors (4) and lock.
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .