Removing the support for the bumper cover
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING SEAL FOR FRONT HOOD .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVE CENTER RADIATOR ORNAMENTAL GRILLE .
- Refer to PARTIALLY RELEASING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to PARTIALLY REMOVING TEMPERATURE SENSOR .
- Refer to REMOVING THE BOTTOM FRONT LEFT AND RIGHT COVER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVE FRONT BUMPER COVER .
- Refer to REMOVING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to IF INSTALLED: REMOVING FRONT RADAR SENSOR (FRS) WITH BRACKET .
- Refer to REMOVING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to REMOVING PEDESTRIAN PROTECTION SENSOR .
- Refer to REMOVING THE LEFT AND RIGHT FANFARE HORN .
- Refer to REMOVING STIFFENING STRUT .
- Refer to REMOVING LEFT AND RIGHT BRAKE AIR DUCT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING INTAKE PORT .
- Refer to PARTIALLY REMOVING THE AIR DUCT RADIATOR .
- Refer to REMOVE SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
NOTE:
The operations shown only for one side must be carried out on both sides.
- Release screw (1)
using special tool 2 464 950
.
- Drill out the guide pin (1)
.
- Dia. = 8 mm
- Loosen screws (1) and (2) .
- Remove the support for the bumper cover (3)
forwards.
If necessary, disconnect the present plug connection.