51 64 Front Panel, Front End
5164 TIGHTENING TORQUE OVERVIEW
| Air flap control on front end | ||
| Oval-head screw with spring washer | Tightening torque | 4.6 Nm |
| Cross connection, top | ||
| M8x20 | Tightening torque | 28 Nm |
| Cross connection, top | ||
| M6x20 | Tightening torque | 11.8 Nm |
| Cross connection at the front of the lock | ||
| Combination oval-head machine screw | tightening torque | 28 Nm |
| Holder to support | ||
| M6x20 | Tightening torque | 8 Nm |
| Lower air flap control on bumper cover support | ||
| Oval-head screw | Tightening torque | 4.6 Nm |
| Rear cross connection at the top of the hood latch support | ||
| Flat-head screw M6x20 | tightening torque | 11.8 Nm |
| Rear top cross connection to wheel arch carrier support | ||
| M10x20 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
| Reinforcement strut on bumper cover support | ||
| Hexagon screw | Tightening torque | 28 Nm |
| Strut on front end | ||
| Hexagon screw | Tightening torque | 28 Nm |