Installing the trim panel for the rear shelf

• Install the trim panel for the rear shelf (2)  and thread in the seat belt (3)  .
• Slightly lift the trim panel for the rear shelf (2)  and connect the connectors underneath.
• Insert the trim panel for rear shelf (2)  into the rear guide and position it correctly.
• Mount the expanding rivets (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The description is for one component only. The procedure is identical for all further components.
• Insert the seat belt finisher strip (2)  .
• Clip in the cover (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the right and left side.
• Guide seat belt end fitting (2)  on the left and right into the body.
• Replace screws (1)  .

  Parts:  Screws

• Tighten screws (1)  on the left and right.
  TIGHTENING TORQUE SPECIFICATION
  
  

  End lining to body
  M10 Replace screw.	tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL BOTH C-PILLAR TRIM PANELS .
• Refer to REMOVING REAR SEAT BACKREST .
• Refer to INSTALLING THE REAR SEAT .