Replacing the exhaust turbocharger for cylinders 4 to 6

CAUTION: Heavy component 
Heavy components can lead to injury or damage 

• Remove and install heavy components with the aid of another person/other persons

NOTE: RISK OF DAMAGE 
Damage of the electric wastegate valve controller 
Excessive force when removing and installing a jammed exhaust turbocharger may damage the electric wastegate valve controller 

• Do not pull on the electrical wastegate valve controller or on the coupling rod
• Apply force only at the turbine housing and exhaust manifold
• Do not pull on the compressor housing

• Loosen screw (1)
• Feed out oil feed line (2) and remove

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1)
• Feed out the connecting bracket (2) and remove it

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1)
• Guide out and remove holder (2)

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the sealing ring (1) for damage and replace if necessary

  Courtesy of BMW OF NORTH AMERICA, INC.

• Sealing surface (1) must be free of oils, greases and cleaning agents

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the sealing rings (1) of the oil feed line (2) for the cylinders 4 to 6 with the special tool 0 496 714 (00 9 030)

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: RISK OF DAMAGE 
  Dry running due to insufficient initial filling of the exhaust turbocharger 
  Damage to the exhaust turbocharger 

  • Be sure to do the initial filling when replacing the exhaust turbocharger
  • Fill the exhaust turbocharger with the matching additive (see applicable BMW parts catalogue)
• Fill exhaust turbocharger additive (1) into the bore (2) of the oil feed line

  Courtesy of BMW OF NORTH AMERICA, INC.

  CONSUMABLE DESCRIPTION
  
  

  Exhaust turbocharger additive, gasoline MSP

  17 ml, Tube

  83192457276

• Insert and install the oil supply line (1)
• Tighten down screw (1)
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Oil feed line to exhaust turbocharger
  M6 x 12	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the connecting bracket (2)
• Tighten down screw (1)
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Connecting brackets on exhaust turbocharger
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the holder (2)
• Tighten down screw (1)

TIGHTENING TORQUE SPECIFICATIONS

Holder on exhaust turbocharger for cylinders 4 to 6
M6X14	tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.