Installing the guide for the rear bumper panel at the side

• Position the guide for the rear side bumper cover (3)
• Lock (1) must engage audibly
• Clip in the clips (2) of the vehicle wiring harness

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1)
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear bumper cover guide on the side of the body
  Nut and washer assembly with paint scrape groove	Tightening torque	5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to IF INSTALLED: INSTALLING THE EMERGENCY HORN (ADDITIONAL WORK ON ANTI-THEFT ALARM SYSTEM) .
• Refer to IF INSTALLED: INSTALLING THE LANE CHANGE WARNING SENSOR .