Install the lower right deformation element
NOTE:
Description is for left component only. Procedure on the right side is identical
Install the bottom deformation element
- Feed in the deformation element (2)
- Tighten the screws (1)
TIGHTENING TORQUES SPECIFICATION
| Deformation element, bottom to adapter, front axle support | ||
| M10x60 screw | Tightening torque | 40 Nm |
Follow-up work
- Refer to INSTALLING SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
- Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .