Installing the support for the bumper cover
- Feed in the support (1) at the front end (2) and position it correctlyNOTE: Perform the steps on the right and left side
- Tighten the screws (1)TIGHTENING TORQUES SPECIFICATION
Vertical connection to deformation element Hexagon screw Tightening torque 21 Nm - Tighten the screws (2)TIGHTENING TORQUES SPECIFICATION
Vertical connection to deformation element Hexagon screw Tightening torque 21 Nm - Mount the expanding rivets (1)
Follow-up work
- Refer to INSTALLING THE FRONT END .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
- Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to INSTALLING THE LEFT AND RIGHT HEADLIGHT .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .
- Refer to ADJUSTING HEADLIGHTS .