Install the side trim panel in the footwell at the left A-pillar

• Check the clips (3) for damage and replace if necessary
• Position the side trim panel (2) and engage it in the clips (3)
• Make sure that the side trim panel (2) is correctly fitted against edge protection
• Tighten down screw (1)
  TIGHTENING TORQUES SPECIFICATION
  
  

  A-pillar footwell side trim panel
  screw	Tightening torque	2.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install hood release lever (1)
• Pull the hood release lever (1) to the rear
• Install locking wedge (2)

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE DOOR SILL COVER STRIP .
• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .