Install charge air line

• Check sealing ring (1) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9 030) .
• Check sealing ring (2) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9 030) .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install charge air line (4).
• Lock clamp (3).

  The clamp (3) must engage audibly.

• Insert and install the coolant hose (2).
• Lock clamp (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Charge air line to throttle valve
  M6x30	tightening torque	8 Nm

• Connect connectors (2) and lock.

  The connector (2) must engage audibly.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and position auxiliary coolant pump (4).
• Feed in and position retaining bracket (3).
• Tighten nut (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Electric coolant pump to holder
  M6	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

Follow-up work 

• Refer to INSTALLING BOTTOM CLEAN AIR PIPE .
• Refer to INSTALLING CLEAN AIR PIPE, TOP .
• Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .