Installing the bearing bracket for the pedal mechanism

• Install bearing bracket (2).
• Replace the screw (1).

  Parts:  Screw

• Position and tighten the screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Pedal bracket on body
  M8 Replace screw.	tightening torque	22 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nuts (1).

  Parts:  Nuts

• Install the nuts (1) and tighten.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Brake booster to pedal assembly console  Replace nuts.
  M8 Retighten 1x on brake booster after 10 min.	tightening torque	22 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock brake pedal (1) in place in the arrow direction with the brake booster.
• Make sure that the brake pedal is completely locked  with the brake booster!

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BRAKE LIGHT SWITCH .
• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .