Install The Outer Section Of The B-Pillar
NOTE:
TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment
- Clean bonding surfaces with cleaning agent R1.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of cavity sealing (expanded) - Apply sealant to the cavity sealings (1) .
- Apply adhesive K5a to area (2) .
- Install the new part and reinforcement plates in areas (3) and (4) as per new part preparation processes.
Follow-up work
- Refer to ACTIVATE HIGH-VOLTAGE SYSTEM .