Tighten the screws on the left and right front axle support
- Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Front axle carrier to body, front M12
Replace screws.Joining torque 108 Nm Angle of rotation 45° - Replace screws (2).
Parts: screw
- Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Front axle support to center of body M12
Replace screws.Joining torque 108 Nm Angle of rotation 45° - Replace screws (3).
Parts: screw
- Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Front axle carrier to body, rear M14
Replace screws.Joining torque 108 Nm Angle of rotation 45° NOTE: Perform the steps on the right and left side. - Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Bottom bumper bracket on the front subframe. M8x100
Replace screws.Tightening torque 19 Nm