Removing and installing/replacing side trim panel, footwell, on A-pillar, left (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front door (inside) SILL COVER STRIP .
- Remove pedal mechanism TRIM PANEL .
Detach edge protection (1) in area of side trim panel (2).
Release screw (3).
Remove engine compartment lid release lever (4) from side trim panel (2).
Installation note:
Make sure EDGE PROTECTION (1) is correctly seated.
Release screw (1).
Unclip side trim panel (3) in direction of arrow from retaining points (2).
If necessary, disconnect associated plug connection and remove side trim panel (3).
Installation note:
If necessary, lever out clamps (1) remaining in bore.
Replace faulty clips (1).
Position side trim panel (2) pre-installed with clips (1) on associated bore holes and clip into place.
Replacement:
Modify rear lid unlocking SWITCH , if applicable.