Remove wiring harness
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Loosen screws (1).
- Release the cable (2).
- Removing balance weight (3)NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
- Disconnect the plug connection for the vibration actuator.
- Fold open foam material (1).
- Loosen screws (2).
- Release the grounding cable (arrow)
- Remove vibration actuator (3).
- Unlock plug connection (1) and disconnect.
- Unlock and unplug the plug connection (3) if necessary.
- Disconnect grounding cable (2).
- Loosen screw (4).
- Feed out wiring harness and remove.