Removing and installing/replacing rear spoiler (330i xDrive Wagon, 328d xDrive Wagon)

Special tools required: 

• 510 010

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Lever out seal plugs (1) and release screws underneath.

Tightening torque 51 71 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rear spoiler (1) in the direction of arrow and pull out of guides.

Tilt rear spoiler (1) upwards slightly.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connection (1) for washer jet and plug connection (2) at additional brake light.

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out marked retaining lugs and remove cover (1) in the upwards direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Pull out cable (2) and remove rear spoiler.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting the rear spoiler 

Observe BODY DIMENSIONS .

Press on rear spoiler (1) and measure gap of the rear spoiler (1) to the rear window (2) using special tool 51 0 010.

A = 1 ±1 mm

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Modify ADDITIONAL BRAKE LIGHT .

Using a suitable tool, lever out the retaining lugs (1) of the cover (2).

Pull cover (2) off the rear spoiler (3).

Modify the AERIAL if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Retaining lugs (1) of cover (2) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.