Removing and installing/replacing trim panel for D-pillar left (right) (330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

When working on trim panel components, make sure that visible surfaces are not scratched or damaged.

Necessary preliminary tasks:

Remove TRIM PANEL for roof pillar at rear (C-pillar)

Release the trim panel (1) on the clips (2) in the marked area with the special tool 00 9 325.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Release the trim panel (2) on the clips (3) in the marked area with the special tool 00 9 325.

Feed out trim panel (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Clips (1) on the trim panel (2) must not be damaged or missing.

If necessary, replace faulty clips (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic similar.

Installation note:

Lip of edge protection (1) in area of trim panel (2) must not be trapped, feed out if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.